I had to fight permissions problems all day that didn’t end up being Apple’s fault. But I got them in the end and JUST managed to sneak it before Monday.
I was looking at your video on color pop mode and noticed that the MAC OS version doesn't have the slider on the far right of the screen as shown in the video...... where you set it to 0.5
LOL. I checked my email before going to bed and seen the update. I don't know what you mean by filament 'sets'. It looks like the update loaded the filaments I already had from the previous version. It was only four colors, but it seemed to do a good job. I'll be playing around with it later this week after I finish a few non-HueForge prints for customers.
Under the filament library next to the button that almost says Add/Update is a dropdown box - that is full of sets of filaments that make up different color schemes. I made a few Color Aware sets (Polymaker and Bambu) that are mostly right when loaded.
I was looking at your video on color pop mode and noticed that the MAC OS version doesn't have the slider on the far right of the screen as shown in the video...... where you set it to 0.5
Did you turn on Color Pop mode? It won't be there unless you are in Combo or Color Pop, the only two modes that use it.
Thank you! I did a quick test using Color Aware and I like it so far. :)
That was fast. Did you use one of the included Filament Sets to help get started?
LOL. I checked my email before going to bed and seen the update. I don't know what you mean by filament 'sets'. It looks like the update loaded the filaments I already had from the previous version. It was only four colors, but it seemed to do a good job. I'll be playing around with it later this week after I finish a few non-HueForge prints for customers.
Under the filament library next to the button that almost says Add/Update is a dropdown box - that is full of sets of filaments that make up different color schemes. I made a few Color Aware sets (Polymaker and Bambu) that are mostly right when loaded.